Table of Contents
Advertisement
O P E R A T I O N
M A N U A L
RECORD OUTPUT
The output terminal OUTPUT REC (22) must be connected to the recording
input of an analog recording device (mostly named TAPE IN or REC).
This output provides the signal of the selected input of the RECORD level at
maximum volume level. Signals from the inputs TAPE and SURROUND cannot be
taken from the RECORD output.
Through factory settings, volume controls have no bearing on the signal at the
RECORD output.
If no recording is desired, the RECORD output may be used as a second volume
controlled preamp output. (see chapter RECORD SETUP)
The pinning of the OUTPUT REC is: PIN1=GND, PIN2=NEG, PIN3=POS.
NOTICE:
Never connect a power amp or active loudspeakers to this
output with these settings. Serious damage to your ears and equipments
may occur.
HEADPHONE JACKS
The headphone jacks PHONES 1 (19) and PHONES 2 (20) require headphones
with a
,
mm stereo plug and an impedance of
6
3
output can playback the MAIN and the RECORD level. The PHONES MENU gives
you the option to choose your favorite settings. The volume level is being reduced
to
01
respectively -
79
dB while inserting or pulling off the phones plug. With the
volume selector (6) on the front panel or with the buttons VOLUME + and.
VOLUME – on your remote control you select the volume level of the phones
outputs.
NOTICE:
The signal at the MAIN or RECORD output will be interrupted
while inserting a headphone plug into the headphone jacks.
2 4 | 7 6
Ω or more. Each of the phones
16
REMOTE
Connecting DC OUT (27) to the corresponding DC IN-jack of another BURMESTER-
unit offers the function to switch on or off this other unit simultaneous by the
this case, the
077
has the master function.
Connecting DC IN (28) to the corresponding DC OUT-jack of another BURMESTER-
unit offers the function to switch on or off the
077
this case,
077
has the slave function.
BURLINK
To the BURmester-LINK interface plugs (17), (18) a computer system e.g. PC,
CRESTRON
, AMX
can be connected to the preamp
TM
TM
allows a comfortable control of your High End system using for example an indivi-
dual programmable touch panel. With the LEDs beside the plugs named T and R
(Transmit and Receive) you are able to monitor whether data exchange is working.
You will find the commands to control the
077
0 7 7
P R E A M P L I F I E R
077
. In
simultaneous by the other unit. In
077
. The computer system
in the chapter BURLINK.
2 5 | 7 6
Advertisement
Table of Contents
