Table of Contents
Advertisement
O P E R A T I O N
M A N U A L
General Instructions
Please read the owner's manual carefully and keep it safely. If you have any
questions, we ask you to contact your local authorized dealer.
OPER ATING TEMPER ATURE
An operating temperature that is too high or too low may cause malfunctioning.
We therefore recommend letting the unit settle for a while after unpacking before
connecting and operating it.
SETTING UP
When choosing a place for your equipment please observe the following:
•
Avoid direct sunlight.
•
Do not expose the equipment to excessive heat, cold, humidity or dust.
•
Provide adequate air circulation; avoid placing the equipment in enclosures.
•
Slots and other openings in the housing are for ventilation. They must not be
covered up.
•
Please make sure that the component is not exposed to dripping water or splash
water, also don't place boxes with liquid onto your component.
Open flames like candles must not be placed on top of any electronic unit.
•
MAINS VOLTAGE
Check before operating the unit to see if the mains voltage setting shown on the
back panel below the AC mains input conforms to the voltage of your household
power supply. Any changes should only be done by an expert only.
- For AC connection please use only the three-pronged power cable provided.
The grounding pin should not be bypassed under any circumstances. Connect the
component only to a wall outlet with fully functional grounding pin.
COMM. OPER ATION
Before installation switch off all other components of your hifi system. Switch them
back on only after making sure that all connections have been made correctly and
completely.
Never try to operate the equipment when it has obviously been damaged or if liquid
has gotten into it.
7 0 | 7 6
TERMINALS
The pins of the connecting terminals on the back panel must not be touched under
any circumstances. Static discharges may damage the electronic circuitry inside
the unit.
INTERCONNECTS
We supply custom-made balanced as well as unbalanced interconnect cables
and speaker cables of any length to ensure highest-quality signal paths for our
components. The impedance of our cables is ideally matched to all BURMESTER
components.
For the cleanest power supply we recommend our triple-shielded power cord
BURMESTER-POWER.
IR RECEIVER
The IR receiver receives signals from the BURMESTER remote control and must not
be covered up by any objects.
HEAT DEVELOPMENT
Be careful when touching the housing – it may get quite warm during operation.
RESET
If the unit does not react when pressing the control keys on the front panel it may be
reset to normal operation by switching it off and back on using the AC mains switch
in the back.
LIGHTENING STRIKES
During the summer months, malfunctions often occur due to voltage spikes in the
power lines after lightning strikes. Completely unplugging the power cord offers the
only effective protection. Merely switching the unit off does not suffice since
voltage spikes are able to arc over separated contacts.
FUSES
The fuses are located inside the unit and should only be changed by a qualified
technician.
0 7 7
P R E A M P L I F I E R
7 1 | 7 6
Advertisement
Table of Contents
