Table of Contents
Advertisement
O P E R A T I O N
M A N U A L
Special Functions
The preamp
offers a variety of special functions in order to allow a personalized
077
configuration of the device. Most functions are adjustable in the SETUP MENUS.
RECORD OUTPUT
Through factory settings the OUTPUT REC (22) of the preamp
connected to an analog tape recorder. Meaning, the recording volume is fixed.
If required, this setting can be changed. The RECORD output can be programmed
as additional volume controllable preamp output. In this setting, it is possible to
provide a second room with music. The REC output is able to reproduce a different
source than the MAIN output and is volume controllable in itself.
To change the output from FIXED to VARIABLE you have to go to the RECORD
SETUP in submenu REC.
For specific instructions please refer to THE SETUP MENU/ RECORD SETUP.
SURROUND INPUT
Through factory settings the SURR/INPUT 6 (23) of the preamp
a SURROUND input. The signal is transported directly to the MAIN output, avoiding
volume control and all amp stages.
If you prefer not to connect a surround decoder, you can use the input as regular
high-level input with volume control (like INPUT
available in the MAIN SETUP in submenu M-IN6.
For specific instructions please refer to THE SETUP MENUS / MAIN SETUP.
NOTICE:
In RECORD level INPUT
input.
3 0 | 7 6
is preset to be
077
077
is preset as
1
to
5
). Adjustment options are
6
is always a regular high-level
VOLUME SCALE
Through factory settings the volume steps are set to the BURMESTER curve.
The volume indicator is divided into steps between
volume).
You may change the setting to dB steps. This can be adjusted individually for the
MAIN and RECORD level.
Adjustment options are available in the MAIN SETUP in submenu M-SCALE.
The adjustment for the RECORD level can be found in the RECORD SETUP in
submenu R- SCALE.
For specific instructions please refer to THE SETUP MENUS/ MAIN SETUP
and RECORD SETUP respectively.
OUTPUT AMPLIFICATION
Through factory settings the entire volume of the preamp
amplification of +
5
dB (factor
1
.
8
). This preset should be maintained if you are
operating your system with BURMESTER power amps, which have a high input
sensitivity. If you are operating the preamp
077
with low input sensitivity, it is possible to change the maximum amplification to
+
dB (factor
.
).
21
11
2
Adjustment options are available in the MAIN SETUP in submenu M-OUT.
For specific instructions please refer to THE SETUP MENUS/ MAIN SETUP.
NOTICE:
The RECORD level has a maximum amplification of +
(factor
1
.
8
) when set to preamp function. The amplification of the
RECORD level cannot be adjusted.
At fixed volume the signal is put through to the RECORD output without
any influence of the preamp.
0 7 7
P R E A M P L I F I E R
0
(mute) to
60
(maximum
is set to a maximum
077
with power amps or active speakers
dB
5
3 1 | 7 6
Advertisement
Table of Contents
