Maintenance
4.4. Wet Cut Rotary Union Removal
If the rotary union shaft becomes scratched or damaged, it will be necessary for the rotary union to be
replaced in order to properly seal the system (refer to
D A N G E R : To minimize the possibility of bodily injury or death, disconnect all electrical power
prior to making any mechanical adjustments.
Step 1: Remove power to the stage.
Step 2: Remove the rear carriage cover and top carriage cover located on the backside of the carriage (see
Section 4.3.3. Wet Cut Rotary Union Seal Replacement
42
VascuLathe
Figure 4-13
Figure 4-13:
Wet Cut Rotary Union
Chapter 4
®
-ACS Hardware Manual
for a view of the rotary union assembly).
for the removal procedure).
www.aerotech.com