Table B-2: Archived Changes - Aerotech VascuLathe ACS Series User Manual

Technical Changes
Table B-2: Archived Changes
Revision
1.00.00
1.01.00 Section 1.3. Model Numbers
Section 2.5.1. Collet Installation and
Removal Procedure
Section 3.2. Basic Specifications
Section 3.3. Load Capability
Section 4.3.3. Wet Cut Rotary Union
Seal Replacement
Section 4.4. Wet Cut Rotary Union
Removal
1.02.00 Section 2.11. Wet Cut Fluid Require-
ments
Section 1.4. Dimensions
All
1.03.00 Section 4.2.1. Collet & Collet Chuck
Lubrication and Cleaning
1.04.00 Section 1.6. EC Declaration of Incor-
poration
Section 3.1. Environmental Spec-
ifications
Chapter 2:
Unpacking and Handling the
Section 2.3. Securing the Stage to the
Mounting
trical
Safety Procedures and Warnings
Section 3.2. Basic Specifications
54
Section(s) Affected
--
Installation, Section 2.1.
Stage,
Surface, Section 2.9. Elec-
Installation, and Section 1.5.
Appendix B
®
VascuLathe -ACS Hardware Manual
General Information
New manual
Updated model numbering scheme
Updated collet installation procedure
Updated basic specifications
Added pressure vessel limitations
Changes for wet cut rotary union seal replace-
ment
Added wet cut rotary union removal section
Added wet cut fluid requirements section
Added dimensions section
Changed page numbering from section based to
absolute
Changed collet and collet chuck lubrication and
cleaning instructions
Added section
Added section
Added safety information and warnings
Added motor specifications
www.aerotech.com