Table of Contents
Advertisement
10
1. Read again this user guide and make sure the problem is not caused by a flat
battery or incorrect use.
2. Make sure the batteries are inserted with the correct polarity.
3. If the transmitter does not communicate with the receiver, try to program
communication - see chapter: 7.4 Pairing (programming) the transmitter with the
receiver.
4. If it seems, that the dog does not respond to the stimulation impulse:
Check again the battery in the transmitter and in the receiver.
Test the receiver's functions with a test discharge lamp (see 5
chapter).
Check whether you have choosen correct length of the contact points (see
chapter: 7.5 Choice of the contact points) and ensure contact points are well
tightened and in contact with your dog's skin (see chapter: 7.6 Fitting the training
collar).
If the dog has dry skin, moisten the skin.
5. Check the correct function of the stimulation impulse.
By using test discharge lamp you can easily check correct function of the
momentary/continuous stimulation impulse.
Make sure that the receiver is turned OFF.
Place the test discharge lamp in contact
with each of the contact points - loosen
the contact points, insert the lamp's
outlets under (the contact points so
they are in the touch with the screw and
tighten them (see picture).
Turn on the transmitter and the receiver.
Select
momentary
stimulation for any function button.
The test discharge lamp will increase a light intensity when increasing stimulation
level.
Note: The receiver does not emit any stimulation impulse, when setting the level
00. When using the test discharge lamp the stimulation impulses come on with
less intensity than without the testing lamp.
6. If the problem still persists, contact the dealer.
34
TROUBLESHOOTING
or
continuous
paragraph of this
th
Advertisement
Table of Contents
