Table of Contents
Advertisement
7.4 Pairing (programming) the receiver with the transmitter
Each transmitter has its own radio operational code. The programming of the
transmitter with the receiver enables those two units to work together. When
purchasing new d-control professional set, there is no need to program the device.
The set is programmed from the manufacture. In case you want to use another
transmitter or receiver, you need to program the devices together. Programming
is also necessary for using all four function buttons with one receiver. d-control
professional is compatible with other d-control professional models.
The transmitter is designed for training two dogs, so you can pair it with two
receivers. Function buttons A1/A2 are designed for the dog A and function buttons
B1/B2 for the dog B.
Important: Before the programming make sure no one else is using his d-control
professional or other products from the Dogtrace range close by. Your receiver
could accidentally record the code of his transmitter or interference could
occure. This could someone else transmit some commands into your receiver. If
this occures, program once again the communication of your receiver with your
transmitter.
Pairing (programming) function buttons A1/A2 with the first receiver
1. Turn ON your transmitter.
2. The receiver must be turned OFF.
3. Move the red target of the transmitter towards the receiver so it comes into the
contact with the red target of the receiver and hold for 5 seconds. The red LED
indicator of the receiver will lit up, afterwards the green LED indicator will lit up.
4. After 5 seconds the receiver LED indicators will flash 3 times green and red colour
simultaneously. Afterwards the green and red LED indicators will start alternately
flashing.
5. Press down A1 or A2 button.
6. Successful pairing is indicated by a long beep tone of the receiver.
Pairing (programming) function buttons B1/B2 with the second receiver
Proceed in the same way as in the previous chapter, only in the point 5 press down
the function button B1 or B2.
When you want to use the transmitter for training only one dog, it is possible to
program all four function buttons A1/A2/B1/B2 with the one receiver. You can also
use this function for the professional training and for programming communication
of one receiver with two different transmitters.
Pairing (programming) function buttons B1/B2 (or second transmitter) with the
first receiver
1. Turn ON your transmitter.
2. The receiver must be turned ON.
3. Move the red target of the transmitter towards the receiver so it comes into the
contact with the red target of the receiver and hold for 5 seconds. The green LED
indicator of the receiver will lit up, afterwards the red LED indicator will lit up.
28
Advertisement
Table of Contents
