Programming (Coding) The Transmitter With The Receiver - Dog trace d–control 200 mini User Manual

Programming (coding) the transmitter with the receiver

Each transmitter has its own operational code. The programming of the transmitter with the receiver
enables the two units to work together. This operation will help you to program the receiver to work
with a new transmitter or to program a new receiver to work with your existing transmitter. Receiver
can be reprogrammed indefinitely, either with the same transmitter or a new d-control transmitter. It
is possible to program an unlimited number of receivers to one transmitter.
Switch on the transmitter. The receiver must be switched off.

Select dog A using the

Approach the low area of the transmitter where the magnet is located until coming close to the

indicator located on the receiver (see the picture on the page 8), hold for 5 second, the receiver LED
indicator will flash four times in green and red simultaneously indicating the receiver is in
programming mode.
Move your transmitter away and press the tone signal button on the transmitter. A beep sound is

emitted; the receiver is then synchronized with the transmitter.
Select dog B using the

when programming additional receiver for second dog).

IMPORTANT: Before the programming make sure no other person is using his d-control or
other products from the Dogtrace range close by: your receiver could accidentally record
the code of his transmitter.
button on the transmitter.
button on the transmitter and proceed in the same way (applicable
9