Programming (Matching) Of The Remote Controller And The Receiver - Dog trace d–control 402 Service Instructions Manual

Programming (matching) of the remote controller and the receiver

Every remote controller has its own RF operational code. Programming of the remote controller with
the receiver (collar) will be accomplished during the fi rst use of the DOGtrace™ d–control or with
a new remote controller or a receiver (when one or the other is lost). This operation will enable you
to match your remote controller with the delivered receiver (collar).
IMPORTANT: Before programming is started (before the fi rst use of your receiver or code
rewriting) make sure that no one else uses his/her d–control or another product made by
DOGtrace™ in your neighbourhood – your receiver could randomly receive the code from
the other remote controller and set itself to it. If this happens, program your receiver
once again using your remote controller.
Turn on your transmitter.
Select Dog A using the button on the transmitter
Touch the lower part of your remote controller to the target on your receiver (see the photo on
page 7). The green LED will be permanently lit and after some 6 seconds, it will switch to the
programming mode, indicated by permanent fl ashing of the red LED.
Now take your transmitter away and press down the sound signal button
controller. The codes will be matched in this step and your receiver will produce a sound signal.
Select Dog B using the button on the transmitter and proceed in the same way (it is applicable
when you wish to use your d–control for the other dog by purchasing another receiver or if you
have purchased the d–control 402).
on your remote
9