Dog trace d-control professional 1000 mini Manual page 13

Momentary / continuous stimulation:
This function enables you to activate a safe stimulation warning impulses in the
receiver transmitted by two contact points. The purpose of stimulation impulses
is not to hurt the dog, but this impulse is very unpleasant for your dog. Your dog
will soon create a connection between your command, an audible beep tone and
the unpleasant feeling on the neck. Later on, you will use only a minimum of these
stimulation impulses because the dog will connect them with disobeying your
command.
While transmitting the stimulation impulse, the red LED indicator of the receiver is
emitting a light.
Momentary – stimulation impulse takes only 0,1 second no matter how long the
button is held.
Continuous stimulation – a receiver emits a stimulation impulse as long as the
button is pressed, but for safety reasons, it is limited to 8 seconds.
Choice of stimulation level:
It is important to choose the right intensity of the stimulation impulse for your
dog, therefore it is gently adjustable in 40 levels. Because every dog has a different
sensitivity, you can not estimate the proper stimulation level in advance. Begin at the
lowest levels. If your dog does not respond at a low level, increase it gradually until
you can see a moderate reaction. The stimulation impulse should never cause your
dog a pain or a fear.
TIP: The command stimulation impulse in level 00 does not emit any stimulation
impulses. If you do not want to use the stimulation impulses, set a short and a
long stimulation impulse on the 00 intensity.
Funktion der Vibration:
This function enables you to draw an attention of sensitive dogs or dogs with
a hearing malfunction. It ensures a discreet recall of the dog, which is almost
impossible by deaf dogs and which can not be heard by anyone nearby. It provides
a possibility to disturb the dog during an unwanted activity and to use the moment
of a surprise. Each mode can mean a different command.
Mode
1
2
3
4
While transmitting the vibration, the red LED indicator of the receiver is emitting a
light.
Vibration
discontinuos vibration
continuous vibration
3x
short
−
Period
0,5 s
–
0,5 s
0,2 s
Limit
30 s
30 s
–
–
31