Receiver Preparation - Dog trace d-control 600 User Manual

Receiver preparation

Battery insertion and replacement
1. Screw out 4 screws from the battery cover using a cross-head screwdriver and remove
the lid.
2. Insert the lithium CR2 3V battery into the battery compartment with a correct polarity
(according to the polarity indicated with the "+" symbol in the battery compartment –
see the Fig.). A wrong polarity may damage the unit.
When you insert the battery for the first time, or if the
battery is removed longer than a few tens of minutes, you
will hear an audible beep tone indicating the correct
installation of the battery.
3. Make sure that the rubber seal is clean and correctly
seated in its groove. Clean any dirt from the seal.
4. Put the battery cover of the receiver back and screw in the
4 screws adequately.
Note: When you replace the battery quickly, you
may not hear the audible beep tone of the collar.
Checking the receiver battery status
The status of the battery is indicated by LED indicators on the side of the receiver.
(see chapter: Product description – Receiver)
The batterry is fully charged – when switched on, green LED is flashing.
The battery is low – when switched on, red LED is flashing.
When the battery is low or flat, insert a new CR2 3V lithium battery into the receiver.
Check the correct function.
10
Battery polarity indicator