Programming (Matching) Of The Remote Controller And The Receiver - Dog trace d–control 640 User Manual

Programming (matching) of the remote controller and the receiver

Every remote controller has its own RF operational code. Programming of the remote
controller with the receiver (collar) will be accomplished during the fi rst use of the
DOGtrace™ d–control set or with a new remote controller or a receiver (when one or the
other is lost). This operation will enable you to match your remote controller to the delivered
receiver (collar).
IMPORTANT: Before programming is started (before the fi rst use of your receiver
or code rewriting) make sure that no one else uses his/her d-control or another
product made by DOGtrace™ in your neighbourhood – your receiver could
randomly receive the code from the other remote controller and set itself to it.
If this happens, program your receiver once again using your remote controller.
Turn on your transmitter.
Select dog 1 on the remote controller.
Touch the lower part of your remote controller to the target on your receiver (see the
photo on page 8). The green LED will be permanently lit and after some 3 seconds, it will
switch to the programming mode, indicated by fl ashing of the red and green LED
at the same time.
Now take your transmitter away and press down the sound signal button
remote controller. The codes will be matched in this step and your receiver will produce
a sound signal.
Proceed in the same way when programming the second receiver (for the second collar
for d–control 642, 1042, 1642 models).
on your
9