Page 1
DBM01 Electronic ball dropper User Guide...
Page 2
WARNING: Persons with a personal device for heart activity support (pacemaker, defi brillator) must respect relevant precautionary measures. The product DBM01 emits a stationary magnetic fi eld and an RF signal (Frequency: 869.52 MHz, maximum transmission performance = 25 mW).
Remote controller Ball dropper Indicator lights Ball container cover Control buttons Indicator lights Magnet target Battery space cover Plate for fi xing on vest Note: DBM01 is fi xed to the fi xing plate using a double-sided sticky tape (supplied).
Insertion and exchange of batteries Ball dropper ● Unscrew the battery space cover using a cross screw driver. Insert a CR2 3V battery. Please ensure the correct polarity marked on the printed circuit board. ● Tighten the screws on the battery space cover using adequate force. Battery polarity marking Checking battery status To check the battery status, see the indicator light on the front side.
Page 6
Remote controller ● Unscrew the battery space cover on the back of the remote controller. Insert a CR2430 3V battery. Please ensure the correct polarity (see picture). Tighten the screw on the battery space cover using an adequate force. Battery space Battery insertion Weak battery is indicated by red indicator light after pressing any button.
Switch ON/OFF Ball dropper A magnetic system located in the remote controller is used to switch the ball dropper ON and OFF. ● Switch-on Place the bottom part of the remote controller to the upper edge of the ball dropper (see picture).
The ball dropper emits an audio signal indicating the synchronisation was successful. How to use remote controller Remote controller DOGtrace™ for DBM01 off ers the following functions: ● By pressing the button , a ball is released.
Don’t use any corrosive substances such as diluents, petrol or various cleaners to clean the DOGtrace™ DBM01 set. Use a soft damped cloth, and a neutral cleaning agent if required. The remote controller is not water resistant. Protect it from water and humidity as much as possible.
Warranty The company VNT electronics s.r.o. provides warranty for potential manufacture faults to the extent of two years from the date of purchase. The manufacturer does not take responsibility for damage to the device caused by incorrect use, unauthorised repairs and dismantling. The warranty does not cover the following items: ●...