Table of Contents
Advertisement
Note: When you replace the battery quickly, you may not hear the audible beep
tone of the collar.
Make sure that the rubber seal is clean and correctly seated in its groove. Clean
3.
any dirt from the seal.
Put the battery cover of the receiver back and screw in the 4 screws adequately.
4.
7.2 Checking the receiver battery status
The status of the battery is indicated by LED indicators on the side of the receiver.
(see chapter: 5.2 Product description – Receiver)
The batterry is fully charged – when switched on, green LED is flashing
The battery is low – when switched on, red LED is flashing
When the battery is low or flat, insert a new CR2 3V lithium battery into the receiver.
7.3 Switching the receiver ON/OFF
To turn the receiver ON/OFF (or for programming the transmitter with the receiver) is
used a magnetic switch, marked with the red target on the receiver.
Switching ON
1. Move the red target of the transmitter towards
the receiver so it comes into the contact with
the red target of the receiver. The red LED
indicator of the receiver will lit up, afterwards
the green LED indicator will lit up.
2. When the green LED lighted up, move your
transmitter away from the receiver. The receiver
LED indicator will flash green to indicate the
receiver is ON.
Switching OFF
When switching OFF, follow the same steps as
when switching ON.
1. Move the red target of the transmitter towards
the receiver so it comes into the contact with
the red target of the receiver. The green LED
indicator of the receiver will lit up, afterwards
the red LED indicator will lit up.
2. When the red LED is lighted up, move your
transmitter away from the receiver. The receiver LED indicators will stop flashing.
Important: When turning the receiver ON/OFF hold the red target of the
receiver close to the red target of the transmitter for about 1 second. When
the targets are close to each other for longer than 5 seconds the receiver will
switch to the pairing (programming) mode of the transmitter with the receiver.
This programming mode is indicated by alternate flashing of the red and green
LED indicator. If this occurs, follow the chapter 7.4 Pairing (programming) the
transmitter with the receiver.
27
Advertisement
Table of Contents
