Apply The Decals - Seagull Models MESSERSCHMITT Bf 109E 60 Assembly Manual

APPLY THE DECALS.

If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily ingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and
aid in their location.
If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
ingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
INSTALLING BATTERY - RECEIVER.
Plug the servo leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.
Receiver.
Battery.
Route the antenna in the antenna tube
inside the fuselage and secure it to the
bottom of fuselage using a plastic tape.
he last detail is to install the antenna
onto the fuselage. Use a hobby knife to
cut a slot in the top of the fuselage for the
antenna.
Remove covering to see hole.
Tighten the antenna is removeable so
you can install it at the lying ield to pre-
vent damage in transporting.
31