Installing The Horizontal Stabilizer; Installing The Spinner - Seagull Models SEA 304 Assembly Manual

DHC-1 CHIPMUNK
M6x60mm

INSTALLING THE SPINNER.

Install the spinner backplate, propeller
and spinner cone.
he propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
22
Instruction Manual.
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
2) Using a modeling knife, carefully re-
move the covering at mounting slot of
horizontal stabilizer ( both side of fuse-
lage).
3) Slide the stabilizer into place in the
precut slot in the rear of the fuselage. he
stabilizer should be pushed irmly against
the front of the slot.
Cut.