Seagull Models MESSERSCHMITT Bf 109E 60 Assembly Manual page 17

COWLING.
Tape the cowl to the fuselage using
low-tack tape.
Use a drill and drill bit to drill the holes
for the cowl mounting screws. Make sure
the cowl position is correct before drill-
ing each hole.
Because of the size of the cowl, it may be nec-
essary to use a needle valve extension for the
high speed needle valve. Make this out of suf-
icient length 1.5mm wire and install it into
the end of the needle valve. Secure the wire in
place by tightening the set screw in the side of
the needle valve.
3x10mm
17