5.6.4
Calculation of process data
The process data are calculated in up to seven steps between reading of the ADC and the process data
output:
Name
Offset correction
Filter for averaging over 8
values
60 Hz mode adaptation
Calibration active
AC system offset
Scaling
Table 1: Formulas for calculation of process data
The scaling includes the powers of ten selected in the range.
All gain factors should therefore correspond to 1/8 in order to obtain a total factor of 1. The value 8192
(0x2000) results in a total factor of 1.
EL3681
Calculation formula
for
Version: 3.0
not active
(condition not met)
-
Commissioning
151