Maintenance
Fitting the Leg Assemblies
WARNING! Only use the leg fixing
screws and washers provided with the
FE-55. Apply the torque settings shown
when tightening the fixing screws.
1.
Tilt the FE-55 on it's side with the power switch facing upwards.
Slide the leg assembly with the cable clamp into the leg housing
closest to the power switch panel.
28
2.
With the mounting holes aligned, fit one of the supplied M8 screws
and washers as shown and tighten to the correct torque setting.
x4
M6
x4
M8
3.
Fit one of the M6 screws and washers as shown and tighten to the
correct torque setting.