Pozi-Loc' Tripod Leg Clamp Adjustment - Vinten Protouch PRO-6 HDV Operator's Manual

'Pozi-Loc' tripod leg clamp adjustment

Bedding-in occurs with 'Pozi-Loc' leg clamps, which may necessitate resetting the clamp. Check
the effectiveness of each leg clamp and adjust as follows:
Top clamp
Turn the clamp knob (21)
Remove screw (21.1). Using a suitable peg spanner, back off the threaded insert
slot until the leg is free to move under its own weight.
While sliding the leg in and out, gradually tighten the threaded insert
to grip.
If not aligned, back off the threaded insert
Back off the threaded insert
Install screw (21.1) to secure the threaded insert (21.2).
(21.2)
(21.1)
to the vertical, 'off' position
(21.2) until a slot aligns with the hole for screw (21.1).
(21.2) a further three slots
Fig 9 Top clamp adjustment
Back
(21.2) slot by
(21.2) until the clamp begins
(21)
26