Fitting The Robotic Head - Vinten FE-55 User Manual

2.
Ensure that the camera,
lens and any other
equipment can be
centrally balanced on
the robotic head (i.e. the
mounting plate of the
elevation column.
3.
Ensure that provision is given for sufficient clearance below the
mounting platform to prevent the risk of collisions or trapping
injuries when the column is lowered.
!
4.
Measure to check that the
overall length of the
payload will not exceed
700 mm (27.5 in.) from the
centre of the mounting
plate in any direction.
!
!
700 mm

Fitting the Robotic Head

WARNING! Before fitting, adjusting, or removing the
payload, the elevation column must be lowered to a safe
working height and all four wheel brakes must be applied.
Do not attempt to install the robotic head with the camera or
any payload attached.
The robotic head (FHR-35) is fitted to the FE-55 using a head mounting
plate.
1.
If required in this installation, attach the cable management
bracket to the underside of the head mounting plate. Secure the
bracket in position with the three screws provided.
PZ-1
Installation
13