Main Function Introduction Of Meters, Switches And Lights In The Cab - XCMG XCT80 Operation Manual

XCT80 Truck Crane Operation Manual
6-3-2 Main function introduction of
meters, switches and lights in the cab
1. Start switch (Figure 6-14)
When the key is inserted into the start
switch, four locations can be selected, (KEY
position does not work) as shown in the figure
and their functions are:
OFF: all power off, then the key can be
pulled out.
ACC: when the engine does not start, and
devices such as CD player are used, you can
rotate the key to this position.
ON: power on state, rotate the key to this
position when the engine is working.
START: engine start position.
2.Fuel gauge (9 in Figure 6-4)
When the start switch key is in the ON
position, the fuel gauge shows approximately
the storage capacity of the fuel tank, when the
vehicle is accelerating, braking or the upward
and downward state, the fuel gauge pointer will
change, and generally indicate a lower value
than the actual oil level. When the vehicle needs
refueling, the icon at the bottom right of the fuel
gauge is on to prompt the driver to refuel.
3. Power take-off switch (11 in Figure
6-10) and indicator light (20 in Figure 6-7)
The rear of transmission is equipped with
a power take-off, the power take-off indicator
light goes on when the power take-off works,
which can drive the hydraulic pump to work and
Figure6-14 Starting switch
When you start the engine using the
starter switch in the cab, the gearbox must be
in neutral position.
The components and functions of lower crane portion
6-15
Courtesy of CraneMarket.com