Mounting Arm End Single Pulley - XCMG XCT80 Operation Manual

XCT80 Truck Crane Operation Manual

9-5-2 Mounting arm end single pulley

When driving, the arm end single pulley is arranged on the left side of main crane boom and fixed
using pins A and B, as shown in the Figure9-20.
Pin shaft A
C1 hole
Figure 9-20 Arm end single pulley mounting schematic diagram
1. The arm end single pulley installation methods are as follows:
a. Remove pin shaft A, rotate as rotation axis of pin shaft B, make the arm end single pulley C2
hole to align at the main crane boom C1 hole, plug pin shaft C as shown in the Figure9-21,and steer the
auxiliary lifting steel wire rope by pulley.
b. Turn on the arm end single pulley lifting height limit switch, insert the cable plug into the
control box socket of main crane boom head, and mount the lifting limit switch touch block.
Pin shaft B
C2 hole
9-21
Crane accessory
Courtesy of CraneMarket.com