XCMG XCT80 Operation Manual page 156

2. Transformation from 0°to 30°（as shown in figure9-15）
Remove the lifting wire rope rigging of the auxiliary winch from the auxiliary hook, tie the
auxiliary hook rigging and the auxiliary arm head with the discoloration cotton lifting rope in the
spares and confirm it is firm. Then slowly lift the auxiliary winch, make the auxiliary winch lifting
rope in tension state, pull out the pin axle of the 15° mounting hole on the luffing pulling plate, and
then slowly lower the auxiliary winch wire rope to 30° installation angle state. Install the mounting
pin axle, remove the rigging from the auxiliary lifting arm, and install it on the hook, you can enter the
working condition of 30° installation angle.
Steel wire rope
0° installation
angle state
Figure9-15 Transformation of mounting angle adjustment from 0°to 30°
9-14
Crane accessory
XCT80 Truck Crane Operation Manual
Steel wire rope
30° installation
angle state
Mounting and
dismounting
order of pin hole
Courtesy of CraneMarket.com