Table of Contents
Advertisement
SECTION 3 - CHASSIS & TURNTABLE
Housing - Shaft Assembly
Refer to Figure 3-33.
NOTE: Spray a light film of oil on all component parts during
assembly. Spray a generous amount of oil on bearings dur-
ing installation.
1. Press Bearing Cup (1C) in Housing (1G). Ensure cup starts
square with bore of Hub (1G).
2. Place Bearing Cone (1D) in Bearing Cup (1C) in Housing
(1G).
3. Press Seal (1B) in counterbore of Housing (1G) until
flush with Housing (1G) face. Ensure Seal (1B) is installed
(smooth face up). Apply oil to rubber portion of seal.
4. Invert Hub (1G) and press Bearing Cup (1F) into counter-
bore of Housing (1G).
5. Carefully lower Housing (1G) on Output Shaft (1A) until
Bearing Cone (1D) contacts Output Shaft (1A).
6. Press on small end of the Bearing Cone (1D), being care-
ful not to contact the bearing cage, until Bearing Cone
(1D) seats on shoulder of Output Shaft (1A).
7. Start Bearing Cone (1E) on Output Shaft (1A).
3-20
10. Install Retaining Ring (1I) into groove of Output Shaft
11. Tap Retaining Ring (1I) with a soft metal punch to ensure
12. Install O-ring Plug (1P). Torque to 23 to 24 ft-lb (31 to
Figure 3-33. Housing - Shaft Assembly
8. Press or tap Bearing Cone (1E) on Output Shaft (1A) until
it is just seated in Bearing Cup (1F), while rotating Hous-
ing (1G).
9. Install Bearing Spacer (1H) on Output Shaft (1A) against
Bearing Cone (1F).
(1A). This Retaining Ring (1I) should never be reused in a
repair or rebuild.
WEAR EYE PROTECTION DURING THIS PROCEDURE.
Retaining Ring (1I) is completely seated in groove of
Output Shaft (1A).
WEAR EYE PROTECTION DURING THIS PROCEDURE.
32.5Nm).
31215019
Advertisement
Table of Contents
