Table of Contents
Advertisement
SECTION 3 - CHASSIS & TURNTABLE
OUTER BEARING (19) IS NOT LUBRICATED BY SYSTEM HYDRAULIC FLUID. BE
SURE IT IS THOROUGHLY PACKED WITH RECOMMENDED GREASE, PARKER
GEAR GREASE SPECIFICATION #045236, E/M LUBRICANT #K-70M.
NOTE: Mobil Mobilith SHC ® 460
NOTE: A 102Tube (PN 406010) is included in each seal kit.
NOTE: The coupling shaft (12) will be flush or just below the hous-
ing wear plate surface on Torqlinks™ when properly seated.
The coupling shaft must rotate smoothly on the thrust
bearing package.
3-44
9. Apply a small amount of clean grease to a new seal ring
(4) and insert it in housing (18) seal ring groove.
NOTE: One or two alignment studs screwed finger tight into hous-
ing (18) bolt holes, approximately 180 degrees apart, will
facilitate the assembly and alignment of components as
required in the following procedures.The studs can be
made by cutting off the heads of either 3/8-24 UNF 2A or
5/16-24 UNF 2A bolts as required that are over 0.5 inch
(12.7 mm) longer than the bolts (1) used in the Torqlink™.
10. Install drive link (10) the long splined end down into the
coupling shaft (12) and engage the drive link splines
into mesh with the coupling shaft splines.
NOTE: Use any alignment marks on coupling shaft and drive link
to assemble drive link splines in their original position in
the mating coupling shaft splines.
31215019
Advertisement
Table of Contents
