SECTION 3 - CHASSIS & TURNTABLE
Generator Disassembly and Assembly
Refer to Figure 3-59. and Figure 3-60. to determine if trouble is
in stator, rotor, control box, or combination of these compo-
nents.
1. Rotor
2. Stator Assembly
DO NOT DAMAGE ROTOR OR STATOR WINDINGS DURING DISASSEMBLY AND
ASSEMBLY PROCEDURE.
DISASSEMBLY
1. Mark and disconnect all electrical leads, secure using
cable ties.
3-64
Figure 3-58. Generator Disassembly and Assembly
2. Remove brush holder assembly.
3. Disassemble generator parts shown in Figure 3-58.
4. Clean all parts with approved solvent and dry with com-
pressed air, If applicable.
5. Inspect all part for damage. Replace if necessary.
ASSEMBLY
1. Assemble generator parts using torque values in table.
2. Reconnect all leads. Use cable ties to secure leads away
from moving or hot parts.
31215019