Table of Contents
Advertisement
SECTION 3 - CHASSIS & TURNTABLE
replaced. If the housing has passed this inspection the
disassembly of the Torqlink™ is completed.
3-40
NOTE: Depth or location of bearing/bushing (13) in relation to the
housing wear plate surface and the depth or location of
bearing/bushing (19) in relation to the beginning of bear-
ing/bushing counterbore should be measured and noted
before removing the bearings/ bushings. This will facilitate
the correct reassembly of new bearings/bushings.
22. If bearings, bushing, or thrust washers must be replaced
use a suitable size bearing puller to remove bearing/
bushings (19) and (13) from housing (18) without dam-
aging the housing. Remove thrust washers (14) and
thrust bearing (15) if previously retained in housing by
bearing (13).
31215019
Advertisement
Table of Contents
