JLG 400SC Service And Maintenance Manual page 94

SECTION 3 - CHASSIS & TURNTABLE
2. The Torqlink™ inner housing bearing/bushing (13) can
now be pressed into its counterbore in housing (18)
flush to 0.03 inch (.76 mm) below the housing wear
plate contact face. Use the opposite end of the bearing
mandrel that was used to press in the outer bearing/
bushing (19).
3-42
3. Press a new dirt and water seal (20) into the housing (18)
outer bearing counterbore.
The Torqlink™ dirt and water seal (20) must be pressed in
until its flange is flush against the housing.
31215019