Table of Contents
Advertisement
6. Tighten jack bolt until pinion is completely snug against
shim and bearing. After pinion is snug, loosen jack bolt.
7. Apply High Strength Threadlocking Compound to jack
bolt and jam nut. Torque jack bolt to 50 ft-lb (68 Nm).
8. Tighten jam nut.
9. Torque remaining swing drive retaining bolts to
405 ft-lb (550 Nm).
10. Remove and discard shim.
31215019
SECTION 3 - CHASSIS & TURNTABLE
3.7 SWING BEARING TORQUE VALUES
1. Outer Race - 190 ft-lb (258 Nm) with High Strength
Threadlocking Compound.
2. Inner Race - 190 ft-lb (258 Nm) with High Strength
Threadlocking Compound.
3. See Swing Bearing Torque Sequence.
CHECK INNER AND OUTER BEARING RACES FOR MISSING OR LOOSE BOLTS
AFTER FIRST 50 HOURS OF OPERATION, AND EVERY 600 HOURS THEREAFTER.
3-55
Advertisement
Table of Contents
