TransAct Ithaca 8000 Programmer's Manual page 113

Programming Codes
[ESC] _ Enable/Disable over-score
ASCII [ESC] _ <n>
Hexadecimal 1BH 5FH 01H
Decimal <27> <95> <n>
IPCL &%MO (Begin)
IPCL &%CO (End)
EPOS [ESC] ! <n>
Description The [ESC] _ <1> command begins over-score print mode.
subsequent text, leading spaces, and trailing spaces are over-scored.
[ESC] _ <0> ends the mode.
Note: In EPOS mode, [ESC] ! <n> performs a similar function; however,
near letter quality (NLQ) is not available.
[ESC] W Multi-line double-wide and double-high mode
ASCII [ESC] W <n>
Hexadecimal 1BH 57H <n>
Decimal <27> <87> <n>
IPCL &%FD {n = 1}
&%FS {n = 0}
&%FHA {n = 3}
(Note: Single-wide, double-high mode is not available in IPCL mode.)
EPOS [ESC] ! <n>
Description The [ESC] W <n> command controls multi-line double-wide or double-
high mode, where n specifies the mode:
n = 0 is standard single-wide and single-high;
n = 1 begins double-wide;
n = 2 begins double-high; and
n = 3 begins double-wide double-high.
Note: The [ESC] W <n> command does not affect line spacing.
Note: In EPOS mode, [ESC] ! <n> performs a similar function; however,
near letter quality (NLQ) is not available.
Where n Bits 76543210
1-------
--1-----
---1----
-------X
100-06908
Function
Underline
Double-wide
Double-high
Font: 0 = draft; 1 = large draft
Rev D
®
Ithaca 8000 Programmer's Guide
All
Page 99