TransAct Ithaca 8000 Programmer's Manual page 110

Programming Codes
[ESC] y <12> Disable OCR characters
ASCII [ESC] y <12>
Hexadecimal 1BH 79H 0CH
Decimal <27> <121> <12>
IPCL &%YX012
EPOS [ESC] y <12>
Description The [ESC] y <12> command returns the 30 OCR characters to the
previously selected character set. It does not restore the print mode.
Note: Any character definitions defined by the redefine character set
command are also replaced by the [ESC] y <12> command, documented
in the section Character Attribute Commands
Page 96
®
Ithaca
Rev D
8000 Programmer's Guide
100-06908