Table of Contents
Advertisement
SuperStorage Server 2029P-DN2R24L User's Manual
Installing the Backplane
Installing the Backplane Into the Chassis
1. Power down the system and remove the power cords as described in Section 3-1. Open
the chassis covers as described in Section 3-2.
2. Ensure that all of the hard drives have been removed from the hard drive bays.
3. Place the backplane in the chassis, aligning the holes in the backplane with the
mounting holes in the chassis. Secure with the four screws previously set aside.
4. Reconnect the cabling to the backplane.
5. Replace the backplane shields over the backplane.
6. Plug the power cords into the rear of the power supplies and power up the system.
Backplane
Front Compartment
Figure 3-15. Installing the Front Backplane
50
Remove Four Screws
Advertisement
Table of Contents
