Table of Contents
Advertisement
SuperStorage Server 2029P-DN2R24L User's Manual
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and/or part
numbers given.
Installation or replacement of most components require that power first be removed from the
system. Please follow the procedures given in each section.
3.1 Removing Power
Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non hot-swap components or when replacing
a non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has completely shut-down, disconnect the AC power cord(s) from the
power strip or outlet. (If your system has more than one power supply, remove the AC
power cords from all power supply modules.)
3. Disconnect the power cord(s) from the power supply module(s).
3.2 Removing the Top Covers
Mid-chassis Cover
The mid-chassis cover can be removed to access the fans while the server continues to
operate.
Warning: Except for short periods of time, do not operate the server without the cover in place.
The chassis cover must be in place to allow for proper airflow and to prevent overheating.
Removing the Mid-chassis Cover
1. Power down the system and remove the power cords from the rear of the power
supplies as described in Section 3-1.
2. Remove the two screws securing each side of the top front cover .
3. Push in the release buttons on both sides of the chassis.
4. Lift the top front cover off the chassis.
Chapter 3
25
Advertisement
Table of Contents
