Table of Contents
Advertisement
SUPERSERVER 2028TP-DTR/DTTR/DTFR USER'S MANUAL
6-7
Removing and Installing the Backplane
The SC217HD+ chassis backplane is located behind the hard drives and in front
of the front system fans. Although backplane failure rarely occurs, in the event of
a backplane failure, follow the instructions below.
Removing the Backplane
Removing the Backplane from the Chassis
1. Power down and unplug the system from any power source.
2. Remove the chassis cover.
3. Disconnect the cabling to the backplane.
4. Remove all of the hard drive carriers from the front of the chassis.
5. Remove the five upper screws at the top of the backplane and the screw from
the side of the chassis, as indicated by the arrows below (Figure 6-6).
6. Loosen the three screws in the spring bar, located on the floor of the chassis,
indicated by the arrows below (Figure 6-7).
Figure 6-6. Removing the Screws at the Top of the Backplane
6-8
1
5
Advertisement
Table of Contents
