Supermicro SuperStorage 2029P-DN2R24L User Manual page 31

SuperStorage Server 2029P-DN2R24L User's Manual
After creating the processor package assembly, mount it onto the heatsink to create the
processor heatsink module (PHM).
1. On the heatsink label, locate "1" and the corner next to it. Turn the heatsink upside
down with the thermal grease side facing up, keeping track of the "1" corner.
2. Remove the protective thermal film if present. If this is a new heatsink, the necessary
thermal grease has been pre-applied in the factory. If the heatsink is not new, apply the
proper amount of the thermal grease.
3. In the plastic processor clip, locate the hollow triangle at the corner ("a" in the drawing
below) next to a hole and plastic mounting clips. There is a similar hole and mounting
clips at the diagonal corner of the of the processor clip ("b" in the drawing).
4. With the underside of heatsink and
the underside of the processor
package facing up, align the "1"
corner on the heatsink ("A" in the
drawing) against the mounting clips
next to the hollow triangle ("a") on
the processor package.
5. Also align the corner ("B") at the
diagonal side of the heatsink with
the corresponding clips on the
processor package ("b").
6. Once aligned, press the processor
package assembly onto the heatsink
until the mounting clips (at a, b, c,
and d) snap into place.
The processor heatsink module is
assembled.
Triangle on the CPU
Triangle on the
Processor Clip
Assembling the Processor Heatsink Module
31
Non-Fabric CPU and Processor Clip
(Upside Down)
b
d
B
a
D
Heatsink
A
(Upside Down)
On Locations of (C, D),
B
D
A
On Locations (A, B), the notches
snap onto the heatsink's sides
c
C
the notches
snap onto the heat sink's
mounting holes
C
Make sure Mounting
Notches snap into place