Table of Contents
Advertisement
6. Using the Fax Function
1.
Press the [Image Quality] key.
2.
Press the [ ][ ] keys to select the desired resolution setting, and then press the [OK] key.
• Press the [Escape] key to discard the current change and return to the initial screen.
• You can change the machine's default [Resolution] setting to always scan with a specific resolution
level.
• The "Photo" resolution is not available for Internet Faxes. Faxes will be sent using "Detail" resolution
if "Photo" resolution has been specified.
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Auto Reset Timer] while
the initial screen is displayed.
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
• For details about [Resolution], see p.267 "Fax Transmission Settings".
• For details about [System Auto Reset Timer], see p.298 "Administrator Settings".
Specifying the scanning side according to the original (Type 2 model)
If you are using the Type 2 model, you can specify the machine to scan both sides of original
automatically using the ARDF.
This section describes how to specify the scanning side according to the current original.
• If the machine is in Immediate Transmission mode, this function is not available.
224
CMF139
Advertisement
Table of Contents
