Table of Contents
Advertisement
• When [DHCP] is activated, manually configured IPv6 address settings are not used.
• For details about turning the machine on and off, see p.55 "Turning the Power on".
• For details about printing configuration page, see p.291 "Printing the Configuration Page".
• For details about [Admin. Tools Lock], see p.298 "Administrator Settings".
Configuring the Ethernet Speed
You can set the speed that the machine will use for Ethernet communications.
In most cases, this should be left on the default setting, [Auto Select]. This setting allows two interfaces to
automatically determine the optimum speed when they are connected.
• Connection cannot be established if the selected Ethernet speed does not match your network's
transmission speed.
• The use of this feature is recommended. To use it, select [Auto Select].
Router/HUB
[10Mbps Half
Duplex]
10 Mbps half
duplex
10 Mbps full
duplex
100 Mbps
half duplex
100 Mbps full
duplex
auto-
negotiation
(auto
selection)
[10Mbps Full
Duplex]
-
-
-
-
-
-
-
Machine
[100Mbps
[100Mbps
Half Duplex]
Full Duplex]
-
-
-
-
-
-
-
Configuring the Machine
[Auto Select]
-
-
75
Advertisement
Table of Contents
