Fault 13: Ignition Switch Malfunction - Toro Reelmaster 5010-H Diagnostic Manual

Fault 13: Ignition Switch Malfunction

InfoCenter Display:
Fault Description
The TEC-5002 has detected the ignition S
Circuit Description
The ignition switch has 2 output pins; one for S
output must also be active.
Conditions for Setting the Fault
The key switch must be broken or a short circuit condition must exist to allow an active signal from the S
output to be detected without any active signal coming from the R
Recommended Service Actions
Step 1: Verify that the fault repeats.
1. Clear the system faults from the InfoCenter. Refer to
2. Operate the machine.
Pass The fault did not repeat. Go to
Note:
If the fault does not repeat, an isolated event has occurred.
Fail The fault repeated. Go to Step 2.
_____FAULT #13_____
BAD
input is active but the key R
TART
and one for R
TART
Clearing Faults from the InfoCenter (page
Returning the Machine to Service (page 22)
57
input is off.
UN
. If the S output is active, the R
UN TART
output.
UN
and follow the steps listed.
UN
TART
21).