Toro Diag - Quick Start - Toro Reelmaster 5010-H Diagnostic Manual

Toro DIAG - Quick Start

Ensure that the Toro DIAG software and the drivers for the Toro DIAG Cable (Part No. 115-1944) are already
installed on your PC. If they are not installed, go to the Toro DIAG User's Guide and follow the steps in the
Toro DIAG Software Installation section.
Important:
This procedure assumes that the Toro DIAG Cable has been physically connected to the
PC at least once and that the PC has found and recognized the cable as "New Hardware." If these 2
actions have not occurred, go to the Toro DIAG User's Guide and follow the steps in the Toro DIAG
Cable Installation section.
For the Toro DIAG software to connect between the PC and the machine, perform the following steps exactly
as written:
1. Make sure that the machine is turned off.
2. Turn on the PC, but leave the machine turned off.
Important:
Do not start the Toro DIAG software until later in this procedure.
3. Verify that the access panel from the outer cover of the control arm has been removed
1. Access cover
4. Connect the Toro DIAG Cable (Part No. 115-1944) between a USB port on the PC and the seat harness
connector P27 (CAN diagnostic port) on the machine (See
Figure 9
Figure 10
24
(Figure
and ).
9).
g036005