Toro Reelmaster 5010-H Diagnostic Manual page 99

Location Harness
1 Main
2 Main
1 Main
2
1 Main
2
Pass The CAN bus wiring to the isolation module tested good. Go to Step 8.
Fail The CAN bus wiring to the isolation module did not test good. Repair or replace the damaged wiring.
Go to Returning the Machine to Service (page 22)
Step 8: Replace the CAN bus isolation module.
1. Remove and replace the CAN bus isolation module.
2. Go to Returning the Machine to Service (page 22)
Electrical Diagram
1. 12 Vdc chassis ground
Pin
Connector
P42 E
P42 F
P42 E
Chassis ground
P42 F
Chassis ground
Wire Expected
Color Reading
Green
54 to 66
ohms
Yellow
Green
Open
(infinite)
Yellow
Open
(infinite)
and follow the steps listed.
and follow the steps listed.
Figure 69
99
Connector Graphic
g033142