2.
Ensure that the traction pedal is in the N
3.
Shut off and lower the cutting units. Wait for all of the movement to stop.
4.
Engage the parking brake.
5.
Move the engine speed switch to the L
6.
Open the hood and let the machine cool off to lower motor/generator temperature.
7.
Clear the system faults from the InfoCenter. Refer to
8.
Go to
Returning the Machine to Service (page 22)
position.
EUTRAL
I
position and wait for the engine to slow to low idle speed.
OW
DLE
Clearing Faults from the InfoCenter (page
and follow the steps listed.
277
21).