Toro Reelmaster 5010-H Diagnostic Manual page 252

1. Cutting unit 1, which includes cutting reel motor 1
2. Cutting unit 2, which includes cutting reel motor 2
3. Cutting unit 3, which includes cutting reel motor 3
2. Open the rear discharge of the cutting unit 1 to help cool the cutting unit motor.
3. Reduce the cutting unit reel speed, if possible.
4. Reduce the mowing speed, if possible.
Pass The fault does not repeat. Go to
listed.
Fail The fault repeats. Go to Step 3.
Step 3: Check for any mechanical interference.
WARNING
Contact with the cutting reels or other moving parts can result in personal injury.
•
Keep fingers, hands, and clothing away from the cutting reels or other moving parts.
•
Never attempt to turn the cutting reels by hand while the engine is running.
1. Go to Preparing for Troubleshooting and/or Testing (page 22)
2. Separate system components from the 48 Vdc battery pack by unplugging the 48 Vdc battery disconnect.
Refer to Connecting and Disconnecting the 48 Vdc Battery System (page
3. Check the cutting unit and the cutting reel motor for any mechanical resistance, and make sure that
the reels are free of any foreign debris.
4. Check for proper bedknife adjustment and the overall condition of the reel; adjust the bedknife if it is out
of alignment (see the applicable Cutting Unit Operator's Manual).
5. Connect the 48 Vdc battery disconnect and run the machine to see if the fault repeats.
Figure 134
4. Cutting unit 4, which includes cutting reel motor 4
5. Cutting unit 5, which includes cutting reel motor 5
Returning the Machine to Service (page 22)
252
and follow the steps
and follow the steps listed.
19).
g032972