Adjusting The Traction Interlock Switch; Adjusting The Transport Speed - Toro Sand Pro 3040 Operator's Manual

WARNING
The engine must be running so that you
can perform the final adjustment of the
traction-adjustment cam. Contact with
moving parts or hot surfaces may cause
personal injury.
Keep your hands, feet, face, and other
body parts away from rotating parts, the
muffler, and other hot surfaces.
5. Start the engine and rotate the cam hex
36) in both directions to determine the midpoint
of the neutral span.
6. Tighten the locknut securing the adjustment.
7. Shut off the engine.
8. Install the center shroud.
9. Remove the jack stands and lower the machine
to the shop floor.
10. Test drive the machine to ensure that it does not
move when the traction pedal is in neutral.
Adjusting the Traction
Interlock Switch
1. Adjust the transmission for neutral; refer to
Adjusting the Traction Drive for Neutral (page
29).
2. Activate the pump lever to ensure that all parts
are operating freely and seated properly.
3. Adjust the screw until the air gap is 0.8 to 2.3
mm (0.030 to 0.090 inch); refer to
4. Check for proper operation.
Adjusting the Transport
Speed
Obtaining Maximum Transport
Speed
The traction pedal is adjusted for maximum transport
speed and reverse at the factory, but an adjustment
may be required if the pedal reaches full stroke before
the pump lever reaches full stroke, or if a decrease in
transport speed is desired.
To obtain maximum transport speed, press down
on the traction pedal. If the pedal contacts the stop
(Figure 37) before the pump lever reaches full stroke,
adjust it:
1. Pedal stop
(Figure
1.
2.
3.
4.
5.
Reducing the Transport Speed
1.
2.
3.
Figure 36.
4.
30
Figure 37
Park the machine on a level surface, shut off the
engine, engage the parking brake, and remove
the key.
Loosen the nut securing the pedal stop.
Tighten the pedal stop until it does not contact
the traction pedal.
Continue applying a light load on the transport
pedal and adjust the pedal stop so that it just
contacts or a gap of 2.5 mm (0.100 inch) is
attained between the pedal rod and the stop.
Tighten the nuts.
Park the machine on a level surface, shut off the
engine, engage the parking brake, and remove
the key.
Loosen the nut securing the pedal stop.
Thread the pedal stop out until the desired
transport speed is attained.
Tighten the nut securing the pedal stop.
g002732