Table of Contents
Advertisement
Installing the Rinse Nozzles
Owner provided material: PTFE sealant
1.
Working inside the tank through the 41 cm (16
inch) opening, align the nozzle assembly up
through the 4.5 cm (1-3/4 inch) hole that you
drilled in
Drilling the Spray Tank (page
shown in
Figure
Figure 21
1. Hole—4.5 cm (1-3/4
inch)—rear
2. Plastic flange nut
2.
Assemble the plastic flange nut over the threads
of the bulkhead fitting at top of the tank, and
tighten the flange nut by hand
3.
At the forward 4.5 cm (1-3/4 inch) hole in the
spray tank, repeat steps
other rinse-nozzle assembly
21.
3. Rinse-nozzle assembly
(Figure
21).
1
through
2
for the
(Figure
22).
9)as
1. Plastic flange nut
2. Hole 4.5 cm (1-3/4
inch)—forward
4.
Apply PTFE thread sealant to the threads of the
g206558
both 90° fittings.
5.
Install the 90° fittings into the bulkhead fittings of
the rinse-nozzle assemblies
1. 90° fitting
2. Right side of the machine
6.
Align the hose barb of the 90° fittings to the right
side of the machine
7.
Install the filter basket and close the lid of the
spray tank.
11
Figure 22
3. Rinse-nozzle assembly
(Figure
23).
Figure 23
3. Bulkhead fitting
(rinse-nozzle assembly)
(Figure
23).
g206557
g206567
Advertisement
Table of Contents
