Table of Contents
Advertisement
Note:
If you are operating a 2015 and before
machine, the light on the 3-position switch will
illuminate to indicate that the pump is running.
After 110 seconds, the pump stops running.
Note:
If you are operating a 2015 and before
machine, light on the 3-position switch shuts off to
indicate that power to the pump is shut off.
The 3-position switch remains in the up position until
you move it to the center or N
the switch is in the N
EUTRAL
supplied to the pump and the rinse kit is O
Note:
If you are operating a 2015 and before
machine, the light on the 3-position switch remains
shut off in the N
EUTRAL
Operating the 3-Position Switch for a Manually
Controlled Rinse
Pressing down the 3-position switch energizes a
momentary switch. Power is supplied to the pump for
only for the duration while the switch is held down.
Note:
If you have a 2015 and before machine, the
3-position switch illuminates and the pump runs while
you hold the switch in the D
Release pressure and the 3-position switch moves to
the N
position. Power to the pump is shut off.
EUTRAL
Note:
If you have a 2015 and before machine, the
light in the 3-position switch shuts off.
Filling the Tank
Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut off the
engine, and remove the key.
Remove the rinse tank cap, fill the tank with
approximately 113 L (30 gallons) with clean water,
and install the cap.
Important:
The 113 L (30 gallon) rinse tank is
only intended to be filled with clean water. The
introduction of any other substance to the rinse
tank can cause a safety hazard and/or damage
the machine.
Using the Rinse Cycle
Once the rinse-tank pump has moved 38 L (10 US
gallons) of water into the sprayer tank, the user can
use the agitation switch at their disposal to put the
clean water into the agitation loop. Once finished, the
rinsate can be sprayed out of the boom nozzles or
manually drained from tank. This allows the machine
to move during the rinse processes.
position. When
EUTRAL
position the power is not
.
FF
position.
position.
OWN
1.
Turn on the rinse-tank pump by performing 1 of
the following:
•
Press up 3-position switch for a timed rinse.
•
Press and hold down the 3-position switch
for a desired duration.
2.
Once the rinse-tank pump has moved 38 L (10
US gallons) of water into the sprayer tank, use
the agitation switch to circulate the clean water
through the agitation loop.
3.
Pump the rinsate out of the sprayer tank as
required by federal, state, and local regulations
by performing 1 of the following:
•
Spray the rinsate through the booms until the
sprayer tank is empty.
•
Draining the sprayer tank contents into a
suitable container and disposing of the
diluted solution as required by federal, state,
or local regulations.
The rinse cycle can be repeated again as necessary
for 2 more timed rinse cycles.
21
Advertisement
Table of Contents
