Table of Contents
Advertisement
Figure 2
1. Bolt (2)
2. Hydro guard
3. Nut
2. Remove and retain the (2) bolts securing the neutral
bracket to the underside of the hydro
3. Loosely attach the new hydro guard and the neutral
bracket to the underside of the hydro with the (2) bolts
removed in the prior step. Do not tighten the bolts at
this time
(Figure
2).
4. Loosely attach the cable support bracket to the pump
plate with the new bolt (supplied in the kit) and the nut
previously removed
(Figure
5. Tighten all the bolts and nuts.
g026365
4. Bolt
5. Cable support bracket
6. Pump plate
(Figure
2).
2).
4
Installing the Basket Mounting
Assemblies
Parts needed for this procedure:
2
Guide assembly
2
Bracket assembly
4
Carriage bolt (5/16 x 1 inch)
4
Flange nut (5/16 inch)
1
Basket bracket with guide assembly (right)
1
Basket bracket with bracket assembly (left)
2
Bolt (5/16 x 2-1/4 inch)
2
Flange nut (5/16 inch)
Procedure
1. Remove the cutting units from cartons. Assemble and
adjust them per the Operator's Manual for the cutting
unit.
2. Use
Figure 3
to determine the locations at which
the guide assemblies or bracket assemblies must be
mounted to cutting unit carrier frames.
1. Center basket
2. Left front basket
3. Right front basket
Front Cutting Units
3. Mount a guide assembly to the inside of the right end
of each carrier frame with 2 carriage bolts (5/16 x 1
inch) and flange nuts (5/16 inch) as shown in
Note: The carriage bolts and flange bolts are shipped
installed on the guide assembly.
4. Mount a bracket assembly to the inside of the left end
of each carrier frame with 2 carriage bolts (5/16 x 1
inch) and flange nuts (5/16 inch) as shown in
3
Figure 3
4. Guide
5. Bracket
g195013
Figure
4.
Figure
4.
Advertisement
Table of Contents
