Tightening All Mounting Bolts; Installing The Hood Assembly And Bags; Flange Nut, (3/8 Inch); Curved Washer - Toro 78534 Operator's Manual

Figure 6
For Z597 Diesel Mowers
1. Bolt, (3/8 x 1-1/2 inches)
2. Curved washer, (3/8 inch)
3. Bagger mounting bracket
4. Spacer
5. Bagger side plate
Step
3
Tightening all Mounting
Bolts

No Parts Required

Procedure
The following steps are the correct sequence to
tighten the side brackets and the bagger mounting
bracket. All mounting bolts need to be torqued to
35 ft-lb (48 N⋅m).
6. ROPS

7. Flange nut, (3/8 inch)

8. Side view of bagger side
plate
9. Holes to when installing
the side bracket
1. Tighten the bagger mounting bracket to the
rear frame first.
2. Tighten the ROPS and side brackets to the side
of the mower.
3. If the bagger mounting bracket moves side to
side an 1/8 inch or more, install one or both
of the spacers between the bagger mounting
bracket and mounting plates (Figure 4,
Figure 5, and Figure 6).
4. Tighten the bagger mounting bracket to the
side brackets.
Step
4
Installing the Hood
Assembly and Bags
Parts needed for this step:
1

Hood assembly

3 Bags
2
Clevis pin
2 Hairpin cotter pin
Procedure
1. Install the hood assembly onto the bagger
mounting bracket (Figure 7).
Figure 7
1. Hood assembly
9
2. Bagger mounting bracket