Table of Contents
Advertisement
Installing the Rinse Tank
1.
Assemble the rinse tank onto the machine as
shown in
Figure
Figure 13
1. Rinse tank
2.
Align the hold down with the recess in the top of
the rinse tank
(Figure
Figure 14
1. Bolt (3/8 x 1-1/2 inches)
2. Washer (3/8 inch)
3. Hold down (rinse tank)
3.
Align the slot in the hold down with the hole in
the valve mount
4.
Loosely assemble the hold down to the valve
mount with a bolt (3/8 x 1-1/2 inches), 2 washers
(3/8 inch), and a flange locknut (3/8 inch).
13.
14).
4. Flange locknut (3/8 inch)
5. Valve mount
6. Recess (rinse tank)
(Figure
14).
5.
Repeat steps
at the other recess in the rinse tank
6.
Carefully tighten the bolts and flange nuts by
hand.
Important:
and secure, but the hold down should not
deform or warp the tank.
7.
Replace the supply hose at the rear of the tank
and secure it with the retaining fork removed
previously.
Note:
Once the rinse tank has been initially filled,
check the hold downs and the rinse tank for play (the
weight of the water in the tank can further seat the
tank against the frame). If needed, tighten the bolt(s)
and flange locknut(s) until the hold downs are snug
against the rinse tank—do not deform the tank; refer
to
Inspecting the Rinse Tank Hold Downs (page
g206448
Assembling the Supply Hose
1.
Align the 90° barbed fitting of the supply hose
with the housing for the suction screen
15).
1. 90° barbed fitting (supply
hose)
g206469
2. Housing (suction screen)
2.
Secure the 90° barbed fitting to the housing
(Figure
15) with the retainer fork that you
removed in step
(page
7).
8
2
through
4
for the other hold down
The rinse tank must be seated
Figure 15
3. Retaining fork
4
of
Preparing the Spray Tank
(Figure
14).
22).
(Figure
g206490
Advertisement
Table of Contents
