Table of Contents
Advertisement
1. Retaining fork
2. Bulkhead fitting
4.
Rotate the fitting so that it faces rearward.
5.
Assemble the hose segment—53.3 cm (21
inches) that you cut in
5)
onto the 90° fitting with a hose clamp, and
tighten the clamp by hand
1. 90° fitting
2. Hose clamp
3
Installing the Rinse Tank
Parts needed for this procedure:
2
Hold down (rinse tank)
2
Bolt (3/8 x 1-1/2 inches)
4
Washer (3/8 inch)
2
Flange locknut (3/8 inch)
Preparing the Spray Tank
1.
Loosen the 4 flange-head bolts (3/8 x 1 inch)
and 4 flange locknuts (3/8 inch) securing the
valve mount to the tank frame
Figure 9
3. 90° fitting
Cutting the Hose (page
(Figure
9).
Figure 10
3. Hose—53.3 cm (21
inches)
(Figure
11).
g014260
1. Valve mount
2.
Move the valve mount rearward
Note:
This is a adjustment in the valve mount
location allows space for installing the rinse tank.
3.
Torque the 4 flange-head bolts (3/8 x 1 inch)
and 4 flange locknuts (3/8 inch) to 37 to 45 N∙m
(27 to 33 ft-lb).
4.
Remove the retainer fork that secures the 90°
barbed fitting of the supply hose to the housing
g206662
of the suction screen
1. 90° barbed fitting (supply
hose)
2. Housing (suction screen)
5.
Separate the 90° barbed fitting from the housing
and move the supply hose aside.
7
Figure 11
2. Flange-head bolt (3/8 x 1
inch) and flange locknut
(3/8 inch)
(Figure
(Figure
12).
Figure 12
3. Retaining fork
g206427
11).
g206426
Advertisement
Table of Contents
